Johnson & Jonet
1800 Sal St.
Green Bay, WI 54302


Phone: (920) 406-7400
Fax: (920) 406-7410

About Johnson & Jonet

Johnson & Jonet Mechanical Contractors Inc. was formed in June of 1999 with the intent to specialize in Commercial, Institutional and Industrial Plumbing, HVAC, and Process Piping projects.

Johnson & Jonet Mechanical is a Full Service Mechanical Contractor that specializes in Commercial and Institutional Plumbing, HVAC, Service and Energy Management Installations. We are located in Green Bay, with easy access to our customers to the North & South.
Typical Services & Contract Methods:
Budgeting
Design/Build
Plan & Spec
Time & Material
Preventative Maintenance
Adjustment of Controls
Chiller Inspections & Maintenance
Commercial Boiler Inspections
A/C Tune-ups & Repairs
Rooftop Unit Tune-ups & Repairs
Emergency Services
Installation & Field Service
Our Technical Services Group specializes in Boiler, Chiller and DDC Controls installations & repairs, as well as rooftop equipment, plumbing and process equipment. Our service technicians have the most current factory training to specialize in each of these areas and provide only the best service to our customers.

We can provide field services for: Plumbing installation and service, hot water, steam, or natural gas heating systems, air conditioning and refrigeration installations & repair, DDC/low voltage and pneumatic control work, boiler & chiller installations and repair, state certified backflow testing, and certified pipe welding. Our office staff can provide system analysis, design/build services and turn key project management.


Safety Training

Johnson & Jonet has grown in the past nine years to the point we have hired an outside safety consultant to make sure jobsite safety is a number one concern. Our company stresses safety importance on and off the job site. There is always a “chance” someone could get injured so every precaution is taken to avoid injuries. With safety training, and on site safety inspections, our company’s modification rate has been steadily decreasing. We not only work with the site foreman, but also with our site workers to improve their safety on the job site. Our employees understand that safety is not only for the company’s aspect but for their own family also. Johnson & Jonet provides training and all safety equipment needed to all employees for their protection against injury.

Safety Training For Johnson & Jonet Mechanical
   •   Weekly safety talks for all employees in the field working
   •   Quarterly safety training by our safety consultant for all employees 
   •   Once a month safety walk through for all job sites by our safety consultant
   •   Lock-out tag-out program 
   •   High lift
   •   Fall protection
   •   Electrical safety
   •   Excavations
   •   Hazard communication
   •   Emergency response
   •   First aid & bloodborne pathogens
   •   Confined space entry
   •   Ladders & Stairways
   •   Personal protective equipment
   •   Welding, cutting and brazing
   •   Work zone safety
   •   Scaffolds
   •   Materials handling & storage
   •   Jobsite exposures
   •   MSDS training

You can contact our safety personal Tim Ducat at 920/406-7400 tim@johnsonjonet.com or Cory Delwiche at  920/680-6122 Safety1st@centurytel.net if you have any questions.

 

Thermographic Imaging Services  |   HVAC Technical Services  |   Design Services  |   Process Piping  |  Plumbing  |   HVAC

© 2008 Johnson & Jonet. All rights reserved


Phone: (920) 406-7400
Fax: (920) 406-7410
Thermographic Imaging Services